1. First check to be sure that the safety is off.
2. V/ith the right forefinger pu'l the operating rod sharp y and hold it in rear position. This will eject cartridge that was in the firing chamber. With the of the hand grasp the trigger guard or the grip . Hold the stock against the right hip to support it. place the left hand over the receiver and with the thumb release the clip latch.
The M1 Garand clip is stamped steel. It holds 8 rounds of.30-06 Springfield (or.308 Win. For M1s so chambered). 5-round clips available, but the standard 8-rounder can be loaded with fewer rounds. The 5-rounder isn't necessary. The clip is not a magazine, for it does not completely enclose the cartridges.
3. The clip and whatever cartridges remain in it now pop up into the right hand and must oe re-
from the rifle.
M1 Garand variant; 'White' gas cut-off and expansion system M1E14 Mk 2 Mod 0 M1 Garand variant; rechambered in 7.62×51mm NATO with press-in chamber insert, enlarged gas port, and 7.62mm barrel bushing. T20 N/A M1 Garand variant; select-fire conversion by John Garand, capable of using BAR magazines T20E1 N/A. (84) 84 product ratings - 10-pack of M1 Garand En Bloc Clips 8rd ENBLOC Clip NEW US Made Parts 30-06. Free shipping. 3 new & refurbished from $13.85. The following 30-06 Springfield and 308 Winchester (7.62 x 51 NATO) cartridge loading data is suggested for M1 Garand and M1A (M-14) rifles known to be in good operating condition. This Load Data taken from the Hornady Handbook of Cartridge Reloading 9th edition. M1 Garand 30-06 Loading Data Suggestions All Loads To Be Used At Your Own Risk. If you searching to test Rapid Fire M1 Garand And Reload M1 Garand Mid Clip price.
4. With the right side of the right hand held against _ operating rod handle, force the operating rod slightly to the rear. With the right thumb now push down the magazine follower and permit the bolt to move forward about an inch over the end of the follower.
5. Remove the thumb smartly from the follower and let go of the operating rod handle. The action wi'l close under the tension of the spring. Now press the trigger.
M1 Garand Reload Mid Clip Size
6. If you wish to unload the firing chamber but leave the magazine loaded, pull the operating rod oack as described aoove to eject the cartridge from the firing chamber; then pull the operating rod handle back past its normal rear position, force the clip down, ease the rod far enough to let the bolt handle ride over the top of the clip, then let operating rod go forward.
M1 Garand Handloads
Was this article helpful?
Comments are closed.